The Dolphin 6100 does support decoding of the Data Matrix barcode font. Follow the steps below to verify the Scan Wedge software is properly setup to decode Data Matrix Barcodes. These settings also apply to most Honeywell barcode terminals.
- Start the Scan Wedge Software from the Power Tools area
- Tap the Scan Wedge Icon and select Settings
- Select Symbologies
- Scroll down to Data Matrix and verify it is checked, if not Check it.
- Double Clik the Data Matrix Line
- You will see several values separated by commas
- Verify the very first value is a "1", if it is a "0" then place the cursor in this area and change it to a "1"
- Tap the X to close
- Select File-->Save and close the settings screen
- Answer Yes to restart the Scan Wedge application
Comments
0 comments
Please sign in to leave a comment.